Gliders

The AERO-GLIDE is a simple card and balsa glider that has a wingspan of 20 cm and is designed specifically to be made without the use of a model knife. This model can be built by an 8 year old under supervision. A setting jig is included to ensure that the flying surfaces are correctly aligned. IMPORTANT - This model is being phased out in favour the mark II shown below.

Part No. K002 90p each, 80p each for TEN or more.
School Pack of 35 kits in bulk Part No K010 £22.50 each.

The AERO-GLIDE MkII is an improved version of the original Aero-Glide glider. The flying surfaces are still made of card however the fuselage is made from a stronger wood and incorporates a notch for catapult launch or for using the Aero-Glide Launcher. It has a wingspan of 26.5 cm and is designed specifically to be made without the use of a model knife. This model can be built by an 8 year old under supervision. A setting jig is included to ensure that the flying surfaces are correctly aligned.

Part No. K014 £1.00 each, 90p each for TEN or more.
School Pack of 35 kits in bulk Part No K015 £25.00 each.

AERO-GLIDE LAUNCHER has been designed specifically so that the AERO-GLIDE MkII model can be launched consistently at a pre determined angle and thrust, allowing for meaningful experiments to be carried out. The AERO-GLIDE LAUNCHER is robustly made and should last for years.

Part No. E002 £4.40 each.

The NIPPER is a 30 cm wingspan all balsa wood hand launched glider. All parts are pre-cut but the flying surfaces will have to be sanded into an airfoil section if a good performance is to be obtained.

Part No. A001 £1.15 each

The TITAN II is a 45 cm wingspan all balsa wood hand launched glider. All parts are pre-cut but the flying surfaces will have to be sanded into an airfoil section if a good performance is to be obtained. This model should be flown outdoors for the best results.

Part No. A002 £1.60 each
The SKY HI FLYER is an all balsa hand launch and catapult glider with a 26.5 cm wingspan. The kit includes full size plan, catapult and assembly jig. Parts have to be cut out of printed balsa.

Part No. K019 £1.85 each
Back to Products page.